Use this yield profile to create a rate adjustment by Occupancy ONLY. This means that a rate adjustment will be triggered by ONLY an Occupancy event. Decide As described elsewhere, decide if your will occupancy events as a way to trigger a rule,? If you do, will occupancy be based on the entire Site occupancy (ie all Rooms added together and then occupancy/vacancy analyzed by the entire inventory of the Site); else by Room Type occupancy which would apply the occupancy only to the Room Types allocated as detailed below. In a Room type Type Occupancy setting, for example, if you had 5 KING rooms and had an Occupancy rule based on 20% occupancy, then the system will only enforce that Yield Rule when 2 Kings were booked and would ignore any other Room Types when invoking the Yield Rule. This is a key difference and a property can be setup as one or the other, not a mix of both. For example, raise rates by 10% if occupancy is above 80% and lower rates by 10% if occupancy is below 50%. These yielded tiers can also be set to flat dollar amounts. For example, raise rates by $15 if occupancy is above 80% and lower rates by $10 if occupancy is below 50%. Occupancy setting: Set occupancy "below" AND "above" a percentage occupancy amount to trigger the rate change. I.e. Below 50% |